Forum

Time to sell and move on to another in the 4 seat/ v-8 flava…

$13,000 Firm, no trades. Located 30 minutes south of Las Cruces.

Contact me thru email for phone#; ellizard@yahoo.com 

Offroad only title, can not be registered for plates…

engine
22re stock, electric fan, header, 100 amp chevy alternator conversion.

transmission
r151f turbo tranny with custom made short throw shifter, very trick upgrade.
23 spline cryoed output shaft, HD clutch is about a year old, about 6 runs on it that I can remember.

transfercases
daul ultimate t-case marlin crawler built mc08 billet adapter, both cases are 23 spline thru-out,
2;28 in front, 4;7 gears in the rear. front range offroad crossmember.

(edit) I have the trail tough rear driveline disconnect for front diggs, just never installed it cause I'm too lazy to get the driveshaft shortened,
the bracket for the disconnect is mounted but the the actual disconnect is still sitting in the box, also have a cable actuator for it,
it mounts to the dash board for easy reach and use, no crappy lever/handle behind the seat. Disconnect comes with the buggy.

steering
hydro steering with psc double ended ram, hks power steering pump, oval track resevior and cooler.

front axle
tera flex reverse cut crd dana 60 , dynatrac knuckles, alloy usa 35 spline inner and outter axle shafts, ctm u joints on both sides, richmond 538 gears, and an ARB locker, high steer, 6 lug hubs, 35 spline drive flanges front and rear.

rear axle
tera flex reverse cut crd dana 60 full float , 35 spline double spline axles , full spool , 538 richmond gears, ford explorer disk brakes , 6 lug hubs, aa-fab drive flanges,ruff stuff specialties 3/8 diff cover..

front suspension
3 link with pan hard bar rubicon express joint on lower links upper link has 1.25 heim joints and panhard bar has 3/4 heims on each end . super beefy,
also 3000lb warn ATV front winch to compress front suspension..

rear suspension
standerd 4 link with rubicon express joints on every end of the links
coilovers with remote resevior all bilstien 9100' 17 inch travel shocks with dual rate kits and tender coils on all four shocks

tires
brand new 42" Iroks, bias ply, purchased the front tires about a month ago and the rear tires were purchased in Nov, 09. rear tires have 1 run on them.

wheels
the real deal forged alcoa polished wheels 15x10 6 lug , wheels were sent off to champion bead locks to be built. beadlocks installed and welded @ champion.

Inside the rig
Corbeau ultra ss bucket seats , with black 4 point corbeau seat harness, custom built dashboard hand made by myself,
power tank (runs the front arb ) mounted behind drivers seat on floor , black carpet kit , 20 gallon fuel cell with external MSD fuel pump…

(edit) I also have the custom made brackets to adapt a york compressor to the stock 22re compressor bracket for OBA upgrade along with a 5 gallon air tank.

I will gladly take any intrested persons wheeling in Cruces to let you see it in action.